透過IEEE 802.1q in IEEE 802.1q(Q-in-Q)的方式,我們可以讓VLAN的數量增加超過4096(4096*4096),也可以讓客戶自行設定Trunk穿過Service Provider所提供的Ethernet Solution(如:FTTx)。 假設現在的網路架構為: SW1 F0/1 <- SP VLAN 10 -> SW2 F0/1 兩端的設備都是連接到VLAN 10,因此在兩端的Switch啟用Dot1q Tunnel建立Trunk SW1(config)#vlan dot1q tag native !預設,Native VLAN不會加上tag,如果在Q-in-Q中要針對native vlan加tag,必須使用上述指令 SW1(config)#int f0/1 SW1(config-if)#switchport mode dot1q-tunnel SW1(config-if)#switchport access vlan 10 SW1(config)#system mtu 1508 !一般Switch預設system mtu 1500,為了支援多層tag,必須加大MTU,設定完成必須reload switch SW2(config)#vlan dot1q tag native !預設,Native VLAN不會加上tag,如果在Q-in-Q中要針對native vlan加tag,必須使用上述指令 SW2(config)#int f0/1 SW2(config-if)#switchport mode dot1q-tunnel SW2(config-if)#switchport access vlan 10 SW2(config)#system mtu 1508 !一般Switch預設system mtu 1500,為了支援多層tag,必須加大MTU,設定完成必須reload switch
Comments